A tank water heater usually costs about $900 to $3,000 installed, with an average near $1,400, according to Fixr's national cost guide. This Old House puts a tank-type heater at $1,200 to $2,300 installed. A repair is far cheaper, typically $150 to $750 (Fixr), and Bob Vila lists $221 to $964. Those are national figures, and a local plumbing business will quote the real price after seeing your unit. If the heater is failing, start with our guide to water heater repair and replacement, then use the tables below to judge the quote you get.
How much does it cost to replace a water heater?
Replacing a standard tank water heater costs roughly $900 to $3,000 installed, and the size of the tank and the fuel it burns move the price most. A 40 gallon unit lands near the middle of that range. The table lists published installed prices, which include the new unit and the plumber's labor.
| What you are replacing | Installed price (guide only) |
|---|---|
| 30 gallon tank | $550 to $2,100 |
| 40 gallon tank | $550 to $2,300 |
| 50 gallon tank | $700 to $2,500 |
| 75 gallon tank | $1,100 to $3,400 |
| 80 gallon tank | $1,200 to $3,600 |
| Electric tank (any size) | $500 to $3,500 |
| Natural gas tank | $700 to $2,700 |
| Propane tank | $700 to $2,500 |
| Tankless, for comparison | $1,200 to $3,500 |
The spread inside each row is wide because one quote may be a basic unit swapped in the same spot and another may include new venting, a new gas shutoff or a move to a different part of the house. Treat the table as a guide. A water heater replacement quote is only comparable to another quote when both cover the same work.
What drives the price of a water heater installation?
Six things set most of the price: tank size, fuel type, how hard the unit is to reach, venting changes, permit and haul-away charges, and the plumber's labor. Labor is published at about $300 to $1,500, so two quotes for the same tank can differ by hundreds of dollars.

- Size. Each step up in capacity adds to the unit price. Pick the size your household uses, not the biggest one offered.
- Gas or electric. A gas water heater needs a vent and a gas connection, which adds work. An electric unit needs the right circuit. Our page on gas versus electric water heaters explains the trade-offs.
- Venting. Basic gas venting runs about $300 to $500 in one guide, and more where the old flue cannot be reused.
- New location. Moving the heater or running new utility lines adds cost compared with swapping like for like, so ask for it as its own line.
- Haul-away. Removing the old unit is sometimes billed separately, about $100 to $500.
- Permit. Permit fees are published anywhere from $25 to $1,500. San Joaquin County's building page lists water heaters among the plumbing work that needs a permit, so ask whether your quote includes the permit and who arranges it.
- Upgrades. Choosing a tankless model changes the whole job. See tankless water heater cost for that range.
How much does it cost to repair a water heater?
Most water heater repair bills run $150 to $750, with an average near $450, though a simple fix can cost under $100 and a severe failure can approach the price of a new unit. What you pay depends on which part failed and how much labor it takes to reach it. These are published prices for the part and the work together.
| Repair | Typical price (guide only) |
|---|---|
| Thermostat repair | $75 to $150 |
| Heating element replacement (electric) | $200 to $750 |
| Thermocouple replacement (gas) | $150 to $325 |
| Anode rod replacement | $200 to $300 |
| Leak repair | $50 to $600 |
We found no published price for a gas burner replacement, so we give none. Ask the plumber to price the part and labor separately. A burner often costs more than a thermocouple, and a quote that bundles a burner, a thermostat and a flush may be fine, but you should see each line. Anode rod work has its own page: anode rod replacement.
Is it cheaper to repair or replace a water heater?
Repair is cheaper on the day, but replacement can be cheaper over time once the tank is old or rusting. A common rule of thumb from Rheem is to consider a new unit when a repair would cost more than about half the price of a new heater. Rust on the tank itself generally cannot be repaired.
Weigh these points when you decide:
- Age. If the tank is near the end of its usual life, a repair buys little time.
- Where the water is coming from. A leaking fitting can often be fixed. A leak from the tank body usually means replacement. Our page on a leaking water heater covers how to tell.
- No hot water at all. If you are out of hot water today, a same-day swap may matter more than the saving. Ask any plumbing business whether it can quote an emergency job, and read our note on emergency water heater repair.
How long does a water heater last?
A tank water heater lasts about 8 to 12 years in many published guides, and some sources put it closer to 15 years for a gas tank. Tankless units are usually listed at 15 to 20 years or more. Hard water, skipped flushing and a worn anode rod can all shorten the life of a tank, so age alone is not the whole story.
Maintenance is the cheapest way to protect what you paid. A yearly anode rod check and a flush of the tank cost far less than a new heater. If your unit is past 10 years and leaking, collect quotes before it fails, since a planned swap is easier to price than a rushed one.
How do you compare water heater quotes in California?
Compare quotes line by line: the unit and its size, the fuel type, venting, permit, haul-away, labor and any warranty in writing. California law helps here. A contractor must be licensed if the job needs a permit or the total reaches $1,000, which covers most water heater jobs, and the contract should show a license number you can check at cslb.ca.gov.
This site is a quote service. The plumbing business that visits holds its own license, and you can look up any contractor on the CSLB site before you agree. When you request quotes, give the tank size, fuel type and age of your current unit so each business prices the same job. You can send those details on our price request page and compare what comes back.
